Ricoh Super 8 800z Handle Assembly Replacement

はじめに

This guide will show you how to remove the handle of the Ricoh Super 8 camera. You may wish to do this if you need to replace the handle. To reattach or replace the handle, follow these steps in reverse order.

In Step 6, you will remove the handle itself. This will require you to desolder the wire connections in the handle. To attach a new handle, you will need to re-solder these connections back into place.

Make sure your camera is fully powered off before you begin.

必要な工具と部品

手順1 Handle Assembly

Ricoh Super 8 800z Handle Assembly Replacement, Handle Assembly: 手順 1、 3の画像 1

Ricoh Super 8 800z Handle Assembly Replacement, Handle Assembly: 手順 1、 3の画像 2

Ricoh Super 8 800z Handle Assembly Replacement, Handle Assembly: 手順 1、 3の画像 3

Open the handle's battery compartment and remove the batteries from the handle.

編集

手順2

Ricoh Super 8 800z Handle Assembly Replacement: 手順 2、 3の画像 3

Using the Phillips #000 screwdriver, remove the three screws on the round plate on the right side of the camera handle. This is the side with the handle lock release button.

編集

手順3

Ricoh Super 8 800z Handle Assembly Replacement: 手順 3、 3の画像 3

Remove the round metal plate.
Then, shift the handle so you have clearance to pass one of the legs of the button through the opening.

編集

手順4

Ricoh Super 8 800z Handle Assembly Replacement: 手順 4、 3の画像 3

この手順で使用する道具：

Precision Tweezers

€4.95

購入する

Pull the button out at an angle.
Remove the spring beneath it with a pair of tweezers.

編集

手順5

Ricoh Super 8 800z Handle Assembly Replacement: 手順 5、 3の画像 3

Flip the camera to the other side and remove the screws from the other round metal plate with a Phillips #000 screwdriver.
When replacing this plate, make sure the cutout in the plate surrounds the wiring in the handle. You may break the wiring if the plates are not seated well or if placed incorrectly.

編集

手順6

Ricoh Super 8 800z Handle Assembly Replacement: 手順 6、 3の画像 3

Pull the handle slowly away from the camera and shift the handle to allow access to the wire connections.
Desolder these wires carefully and you can now remove the handle.
For a informative guide on how to Solder/Desolder check out this guide.